Menu

Discussion Forum

New Discussion
Filtra

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

how to input a point mass at the center of the surface

Posted 13 feb 2024, 16:07 GMT-5 Structural Mechanics, Physics Interfaces Version 6.2 2 Replies

Nelson Leon
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

hello i need help trying to set point mass at the center of the surface but it not allowing me to is there another way of doing it?

2 Replies Last Post 14 feb 2024, 12:51 GMT-5
Jeff Hiller COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 9 months ago 13 feb 2024, 17:04 GMT-5
Updated: 9 months ago 13 feb 2024, 17:04 GMT-5

Please upload your mph file. Unless we can see how you've tried to do it and how you defined the surface, we can't answer your question.

Jeff

-------------------
Jeff Hiller
Please upload your mph file. Unless we can see how you've tried to do it and how you defined the surface, we can't answer your question. Jeff
Nelson Leon
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 9 months ago 14 feb 2024, 12:51 GMT-5
Updated: 9 months ago 14 feb 2024, 12:51 GMT-5

here is the mph. so in the lower flexture i want to put a point mass of 5 kg is using the rigid connector is best choice for this type of problem

here is the mph. so in the lower flexture i want to put a point mass of 5 kg is using the rigid connector is best choice for this type of problem

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content