Menu

Discussion Forum

New Discussion
Filtra

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

what values are taken for the "automatic" setting of Interpolation?

Posted 9 mar 2024, 22:38 GMT-5 Optimization Version 6.1 1 Reply

Haiyang Li
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

If P_SIMP is set to be automatic, and theta_min the same. Then what values will be taken for then? See the attached figure to calrify

Attachments:

1 Reply Last Post 10 mar 2024, 03:58 GMT-4
Kristian Ejlebjærg Jensen COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 8 months ago 10 mar 2024, 03:58 GMT-4

The following values will be used with automatic settings

  • P_SIMP=3
  • theta_min=1e-3 with

The documentation fails to mention this, so I will make sure it is improved for the next release.

The following values will be used with automatic settings * P_SIMP=3 * theta_min=1e-3 with The documentation fails to mention this, so I will make sure it is improved for the next release.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content