Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
time dependent coupled thermal structural with slow & fast pressure & thermal pulses.
Posted 2 gen 2013, 18:52 GMT-5 1 Reply
Please login with a confirmed email address before reporting spam
I ran a time dependent coupled thermal-structural problem with temperature dependent structural and thermal properties. When the thermal and pressure pulses were ramped up over two seconds no problem.
Identical problem but only over 5 ms for both pulses. Problem only goes to 3.5 ms and then explodes. Any suggestions?
Thanks,
--
Arthur Rupel
Identical problem but only over 5 ms for both pulses. Problem only goes to 3.5 ms and then explodes. Any suggestions?
Thanks,
--
Arthur Rupel
1 Reply Last Post 3 gen 2013, 02:25 GMT-5
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi
have you checked your termal gradient at initial t=0 ? and do your mesh correctly resolve the gradients ? This is often forgotten or overlooked and might make the solver fail.
I often runa stationary case to get a coherehnt starting point, then run the time series, or I start from a well known temperature profile and I ramp up (smoothed step operator) the BC flux items
--
Good luck
Ivar
have you checked your termal gradient at initial t=0 ? and do your mesh correctly resolve the gradients ? This is often forgotten or overlooked and might make the solver fail.
I often runa stationary case to get a coherehnt starting point, then run the time series, or I start from a well known temperature profile and I ramp up (smoothed step operator) the BC flux items
--
Good luck
Ivar