Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Modeling 3D Induction heating with Frequency-Stationary simulation
Posted 13 gen 2013, 21:01 GMT-5 Low-Frequency Electromagnetics, Heat Transfer & Phase Change Version 4.3a 1 Reply
Please login with a confirmed email address before reporting spam
Hi,
I am trying to simulate induction heating due to a spiral inductor with different core materials. I want to perform a Frequency-Stationary analysis. I have the following problems:
1. The usual terminals of "Current" and "Ground" that are available in the Magnetic Electric Fields (mef) Physics suddenly disappears when the Induction heating Physics (ih) is used (although it combines the same mef module with the heat transfer module). Is there a way to get around this and specify a specific current/ground terminals in the Induction heating module?
2. I tried specifying a lumped port instead. At the input I specified a uniform current and at the output I specified a 50 ohm termination. But the solver in this case gives a "Error in uniform lumped port set up"
Any help with 1. or 2. would be greatly appreciated!
Thanks,
Arvind
I am trying to simulate induction heating due to a spiral inductor with different core materials. I want to perform a Frequency-Stationary analysis. I have the following problems:
1. The usual terminals of "Current" and "Ground" that are available in the Magnetic Electric Fields (mef) Physics suddenly disappears when the Induction heating Physics (ih) is used (although it combines the same mef module with the heat transfer module). Is there a way to get around this and specify a specific current/ground terminals in the Induction heating module?
2. I tried specifying a lumped port instead. At the input I specified a uniform current and at the output I specified a 50 ohm termination. But the solver in this case gives a "Error in uniform lumped port set up"
Any help with 1. or 2. would be greatly appreciated!
Thanks,
Arvind
Attachments:
1 Reply Last Post 18 gen 2013, 05:56 GMT-5
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Dear Arvid,
since the community gave no answer so far, I recommend you submitting your question as a regular support case to us using www.ch.comsol.com/support/
Best regards,
Sven Friedel
since the community gave no answer so far, I recommend you submitting your question as a regular support case to us using www.ch.comsol.com/support/
Best regards,
Sven Friedel