Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Using the Optimization Module for geometry examination
Posted 5 feb 2013, 18:31 GMT-5 Optimization Version 4.3a 2 Replies
Please login with a confirmed email address before reporting spam
Geometry optiization 4.3a
Simple 1D sold state battery problem (in COMSOL)
Done with assistance from COMSOL
M = length of anode 320 nm
L = length of solid electrolyte 1500 nm
objective function = external voltage
time to 2000 sec (time dependent)
If L & M are listed with the mins and the max, no problem.
However if they are coupled - L+M= 1820 nm there seems to be no way to include this in the optimization module.
Does anyone any any ideas?
Thanks
--
Arthur Rupel
Simple 1D sold state battery problem (in COMSOL)
Done with assistance from COMSOL
M = length of anode 320 nm
L = length of solid electrolyte 1500 nm
objective function = external voltage
time to 2000 sec (time dependent)
If L & M are listed with the mins and the max, no problem.
However if they are coupled - L+M= 1820 nm there seems to be no way to include this in the optimization module.
Does anyone any any ideas?
Thanks
--
Arthur Rupel
2 Replies Last Post 15 feb 2013, 11:58 GMT-5
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi Arthur,
not sure about this, but have you tried to define the length of L to be 1820-M?
And you solve only for M then with a min (>0) and max (<1820).
Best regards,
Frank
not sure about this, but have you tried to define the length of L to be 1820-M?
And you solve only for M then with a min (>0) and max (<1820).
Best regards,
Frank
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Thanks, it worked.
--
Arthur Rupel
--
Arthur Rupel