Menu

Discussion Forum

New Discussion
Filtra

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

RF Source

Posted 11 feb 2013, 07:54 GMT-5 RF & Microwave Engineering, Fluid & Heat, Microfluidics 1 Reply

Elham Khamsehashari
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi,

I want to apply a current or a voltage source to a rectangular surface in a COMSOL RF module problem. Would you please let me know how I can do that?

Regards,
Elham
1 Reply Last Post 12 feb 2013, 10:48 GMT-5
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 12 feb 2013, 10:48 GMT-5
Hi

when you say "surface", do you mean a boundary of a 3D domain ? or a 2D model domain ?

Normally one apply sources as boundary "port" or "Terminals" in ACDC/RF physics

--
Good luck
Ivar
Hi when you say "surface", do you mean a boundary of a 3D domain ? or a 2D model domain ? Normally one apply sources as boundary "port" or "Terminals" in ACDC/RF physics -- Good luck Ivar

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content