Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
cantilever buckling simulation
Posted 28 feb 2010, 00:59 GMT-5 1 Reply
Please login with a confirmed email address before reporting spam
Dear all, I would like to do a cantilever buckling simulation. Let's assume the axial direction of the cantilever is x-axis. Do I need to give it a y-axis or z-axis perturbation for the buckling analysis? Thanks.
CMS
CMS
1 Reply Last Post 28 feb 2010, 07:26 GMT-5
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi
as stated in the doc (smeug.pdf), and how I understand it:
normal bucking is obtained from eigenvalue analysis, => for me this means that no lateral load is requird
if you want to check with nonlinear mode and and load the bar up to buckling, it is clear that adding a little transverse load does give an estimate of the precision of the analysis, as mostly this small load comes from mesh inhomogeneities and numerical "noise"
I use the second option often as a check by adding typically 1/1000 lateral load
Hope this helps
Ivar
as stated in the doc (smeug.pdf), and how I understand it:
normal bucking is obtained from eigenvalue analysis, => for me this means that no lateral load is requird
if you want to check with nonlinear mode and and load the bar up to buckling, it is clear that adding a little transverse load does give an estimate of the precision of the analysis, as mostly this small load comes from mesh inhomogeneities and numerical "noise"
I use the second option often as a check by adding typically 1/1000 lateral load
Hope this helps
Ivar