Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Connect a pair of concentric helix into one
Posted 25 feb 2013, 09:33 GMT-5 Geometry Version 4.3 0 Replies
Please login with a confirmed email address before reporting spam
- Revolving and extruding an end of the first helix to the an end on the second helix gives me an error. I use the measure-tool to find the points of the revolving axis, but I suspect that some value is rounded resulting in a slight shift of the geometry which isn't recognizable by just looking at the screen.
- Since I'm working with Induction Heating I have an option called "Periodic Condition". So I add the two boundaries that I want to connect under "Periodic Condition" and then add the boundary for the second winding under "Destination Selection". The results I get say that the whole geometry has the same temperature which is incorrect.
Are there any other ways I can solve the problem or is there something I'm doing wrong in the above mentioned methods I've already tried?
Hello Bilal Butt
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.