Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
2D patterns on 3D geometries
Posted 31 mar 2013, 05:32 GMT-4 Version 3.5a 1 Reply
Please login with a confirmed email address before reporting spam
Hi,
Is there any way to draw a 2D pattern on a surface of a 3D geometry in COMSOL 3.5(a). Suppose we have a block and on the top surface of this block we want to draw a 2D rectangle. Any suggestions?
Regards
Is there any way to draw a 2D pattern on a surface of a 3D geometry in COMSOL 3.5(a). Suppose we have a block and on the top surface of this block we want to draw a 2D rectangle. Any suggestions?
Regards
1 Reply Last Post 31 mar 2013, 09:29 GMT-4
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Open a 3D file.
Right click Geometry and add a block.
Right click Geometry and add a work plane. This gives you a 2D plane to work on, and you can chose which plane (xy, zx etc.)
Under work plane right click Plane Geometry and add a square.
Or left click plane geometry and use the options along to top ribbon to freehand draw any shape you want.
I'm using 4.3a, so it might be a little different to 3.5s, but I hope this helps
Right click Geometry and add a block.
Right click Geometry and add a work plane. This gives you a 2D plane to work on, and you can chose which plane (xy, zx etc.)
Under work plane right click Plane Geometry and add a square.
Or left click plane geometry and use the options along to top ribbon to freehand draw any shape you want.
I'm using 4.3a, so it might be a little different to 3.5s, but I hope this helps