Menu

Discussion Forum

New Discussion
Filtra

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Error: Undefined value found.

Posted 6 mag 2013, 17:43 GMT-4 RF & Microwave Engineering Version 4.2 0 Replies

Zahra Mardy
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi,

I am simulating a nano antenna in RF module and I get this error:

Undefined value found.
- Detail: NaN_or_Inf_found_when_solving_linear_system_using_SOR

I also simulated the same model in 2D axisymmetric with the same frequency and the results were fine. Since I needed to use a different E-field as my source and the model was not symmetric anymore, I had to use 3D simulation. Moreover, I had some difficulties in meshing but I finally found a way to do the meshing without any errors. However, I only can change my mesh elements a little.

Since I used very dense meshes, does anyone know why I see this error?

Thank you.


0 Replies Last Post 6 mag 2013, 17:43 GMT-4
COMSOL Moderator

Hello Zahra Mardy

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content