Menu

Discussion Forum

New Discussion
Filtra

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Finding current through a surface (electrostatics model)

Posted 29 mag 2013, 14:28 GMT-4 0 Replies

Frimann Kjerulf
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I have created a project in comsol 3.4 where I am have a material, with electrodes (contacts) at each end.

I've created a model, and using the electrostatics model, I've defined relative permittivity for all the subdomains. In boundary settings I have set a voltage to one contact, while the other is set to ground. I need to know the electric power running through my material, so I guess the best way would to find out the current and then use Power = V*I .

Can anyone shed a light on how one goes about finding the current running through a surface. Or are there better ways to find the power running through my sample?

I also have access to comsol 4.3b if things are any easier there. I'm only using 3.4 since I'm used to that one.


Kind regards
Frímann

0 Replies Last Post 29 mag 2013, 14:28 GMT-4
COMSOL Moderator

Hello Frimann Kjerulf

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content