Menu

Discussion Forum

New Discussion
Filtra

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Plot at time 0

Posted 6 giu 2013, 14:58 GMT-4 Computational Fluid Dynamics (CFD), Results & Visualization Version 4.3a 3 Replies

Hooman
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi,

I just found that the results of my simulation at t=0 are not exactly the ones that should be. I mean those results are for a time step that is really small after time=0.

You agree that time=0 is not exactly 0 in Comsol?

If you just run the simulation and then stop it before the last time step, you will see the answer for time=0

Thanks,
Hooman
3 Replies Last Post 6 ago 2015, 00:46 GMT-4
Jeff Hiller COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 6 giu 2013, 16:05 GMT-4
It looks like your file is improperly set up: in particular check whether your initial conditions are consistent with your boundary conditions, I suspect they are not.
JF
It looks like your file is improperly set up: in particular check whether your initial conditions are consistent with your boundary conditions, I suspect they are not. JF
Hooman
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 6 giu 2013, 16:41 GMT-4
Jean,


Thanks for the reply.
Would you pleas explain more?
I guess, they are alright. but how can I check that point you mentioned?

Hooman
Jean, Thanks for the reply. Would you pleas explain more? I guess, they are alright. but how can I check that point you mentioned? Hooman
Kondapalli Madhu Vinay
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 9 years ago 6 ago 2015, 00:46 GMT-4
May be instead of recomputing you can change time locally in data of 3d plot group
May be instead of recomputing you can change time locally in data of 3d plot group

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content