Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Meshing Thin Films

Please login with a confirmed email address before reporting spam

Hi!
I have two blocks to mesh, one into each other, in a 3D environment.

The smaller one (inside) is the thin film:
width = 100 µm
depth = 9 µm
height = 20 nm

The bigger one (outside) is:
width = 200 µm
depth = 20 µm
height = 20 µm

The two block are obviously centered one each other.

Any suggestion on how to mesh this geometry?

0 Replies Last Post 12 giu 2013, 06:15 GMT-4
COMSOL Moderator

Hello Paolo Minotti

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.