Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Meshing Thin Films
Posted 12 giu 2013, 06:15 GMT-4 Geometry, Mesh 0 Replies
Please login with a confirmed email address before reporting spam
I have two blocks to mesh, one into each other, in a 3D environment.
The smaller one (inside) is the thin film:
width = 100 µm
depth = 9 µm
height = 20 nm
The bigger one (outside) is:
width = 200 µm
depth = 20 µm
height = 20 µm
The two block are obviously centered one each other.
Any suggestion on how to mesh this geometry?
Hello Paolo Minotti
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.