Menu

Discussion Forum

New Discussion
Filtra

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

poroelastic pellicle squeezed at a constant rate: unknown error

Posted 14 lug 2013, 19:22 GMT-4 Porous Media Flow 0 Replies

Mauricio Rincon
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi

I am trying to simulate the squeezing of a poroelastic pellicle under two flat plates at a constant squeezing rate. However, an error comes up and I really don’t understand the reason. The error is as follows:

Failed to evaluate variable.
- Variable: mod1.poro.uInitZ
- Geometry: 1
- Boundary: 4
Failed to evaluate expression.
- Expression: mod1.poro.uInitZ

Could you give me a hint on this? The model is attached.

Thanks

Attachments:

0 Replies Last Post 14 lug 2013, 19:22 GMT-4
COMSOL Moderator

Hello Mauricio Rincon

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content