Menu

Discussion Forum

New Discussion
Filtra

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Thick Cylinder under pressure

Posted 23 lug 2013, 13:04 GMT-4 2 Replies

Brahmarishi Raj
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Plz tell me how can i model a thick cylinder under pressure as attached in the file.

I made a 2D model, defined material, chose "solid mechanics".
Applied a "boundary load" at inner circle boundaryand other at outer circle boundary.


I got the error "failed to find a solution" The relative error (...) is greater than the relative tolerance............

Regards
Brahmarishi

Attachments:

2 Replies Last Post 24 lug 2013, 04:33 GMT-4
Nagi Elabbasi Facebook Reality Labs
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 23 lug 2013, 14:16 GMT-4
Hi Brahmarishi,

If you model the full cylinder in a static (stationary) analysis you will have a singular system with rigid body modes. That could be the problem. In that case you should model a quarter cylinder instead and apply symmetry conditions on the 2 new boundaries.

Nagi Elabbasi
Veryst Engineering
Hi Brahmarishi, If you model the full cylinder in a static (stationary) analysis you will have a singular system with rigid body modes. That could be the problem. In that case you should model a quarter cylinder instead and apply symmetry conditions on the 2 new boundaries. Nagi Elabbasi Veryst Engineering
Brahmarishi Raj
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 24 lug 2013, 04:33 GMT-4

Hi Brahmarishi,

If you model the full cylinder in a static (stationary) analysis you will have a singular system with rigid body modes. That could be the problem. In that case you should model a quarter cylinder instead and apply symmetry conditions on the 2 new boundaries.

Nagi Elabbasi
Veryst Engineering




Thank you very much, i will get back to you if i have other problems/doubts.

Regards
Brahmarishi
[QUOTE] Hi Brahmarishi, If you model the full cylinder in a static (stationary) analysis you will have a singular system with rigid body modes. That could be the problem. In that case you should model a quarter cylinder instead and apply symmetry conditions on the 2 new boundaries. Nagi Elabbasi Veryst Engineering [/QUOTE] Thank you very much, i will get back to you if i have other problems/doubts. Regards Brahmarishi

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content