Menu

Discussion Forum

New Discussion
Filtra

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

buckling of a beam clamped at both ends with initial stress applied

Posted 2 ago 2013, 14:36 GMT-4 Structural Mechanics 0 Replies

Janet Xiao
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello,

I'm a newbie using COMSOL v3.4 structural mechanics mode.

I'm simulating a silicon beam (~100 micron long, ~500nm cross-section side) clamped at both ends with initial stress applied (in the MPa range). I drew the model with fixed boundary condition at both sides of the beam, entered the initial normal stress values, and ran the simulation using the structural mechanics mode. I could not get my simulated z-displacement value, which is the beam buckling, at the center of the beam (~0.1nm) to match my experimental data (~500nm) for 20MPa applied.

Has anybody simulated similar structure before? Any suggestions?

Thanks,

Janet


0 Replies Last Post 2 ago 2013, 14:36 GMT-4
COMSOL Moderator

Hello Janet Xiao

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content