Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
li_ battery _1d_for_thermal_model
Posted 23 nov 2013, 06:53 GMT-5 Heat Transfer & Phase Change, Battery Design Version 4.3a, Version 4.4 1 Reply
Please login with a confirmed email address before reporting spam
Dear sir or madan,
I got a question when modeling a layer-structured liion battery consited of 2 cells connected in parallel.
is the "li_ battery _1d_for_thermal_model" only designed for the cylindrical battery?
or is it a generic model for all the liion batteries?
cause when I simulate the temperatrue distribution,
I need the heat source generated by the 1d battery model, right?
how can i get the heat source ?
just use the "li_ battery _1d_for_thermal_model",
only change the geometry parameters and definations, keep the other equations the same?
Thanks a lot!
Best regards!
GU ZEZHI
I got a question when modeling a layer-structured liion battery consited of 2 cells connected in parallel.
is the "li_ battery _1d_for_thermal_model" only designed for the cylindrical battery?
or is it a generic model for all the liion batteries?
cause when I simulate the temperatrue distribution,
I need the heat source generated by the 1d battery model, right?
how can i get the heat source ?
just use the "li_ battery _1d_for_thermal_model",
only change the geometry parameters and definations, keep the other equations the same?
Thanks a lot!
Best regards!
GU ZEZHI
Attachments:
1 Reply Last Post 17 dic 2013, 22:03 GMT-5
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Please, no body can answer me?
Thanks a lot for your attention!
Thanks a lot for your attention!