Menu

Discussion Forum

New Discussion
Filtra

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

modelling Magnetic inductance tomography

Posted 4 dic 2013, 01:28 GMT-5 Low-Frequency Electromagnetics, Modeling Tools & Definitions Version 4.3b 0 Replies

Mukund Vemuri
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi
I have my model as attached below. I am trying to show the magnetic fields generated by a coil. I intend to add more coils to this model later and change the materials of some of the circles (i.e. make some of them plastic) and would like to measure the induced voltage in those secondary coils.

1. Just wondering how I should go about this, and whether my current coil model is correct?
2. I find that the magnetic field is not shown beyond one circle, just wondering how i can make it so that it displays magnetic field over entire area?

Thanks
Mukund

Attachments:

0 Replies Last Post 4 dic 2013, 01:28 GMT-5
COMSOL Moderator

Hello Mukund Vemuri

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content