Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Stress gradient of anisotropic material

Please login with a confirmed email address before reporting spam

Hi,

I am using the anisotropic Silicon material parameters and was wondering how to apply a stress gradient to this. I've tried some equations manually and I'm not getting the same results from my COMSOL simulation. I am trying to match experimental results: 0.48 m radius of curvature of a 700 um wide, 25 um high rectangular sample. COMSOL 4a is being used and I'm using the initial stress equation '0.176[MPa/um]*y' currently for Sxx and Syy (0.176 is my calculated gradient). Is this equation correct?

Any help would be great, thanks.
Alan

0 Replies Last Post 6 dic 2013, 06:28 GMT-5
COMSOL Moderator

Hello Alan Paterson

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.