Menu

Discussion Forum

New Discussion
Filtra

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Absolute tolerance convergence criteria for flow simulations.

Posted 9 gen 2014, 05:42 GMT-5 Fluid & Heat, Computational Fluid Dynamics (CFD), Studies & Solvers Version 4.3b 0 Replies

Morten Hygum
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hey.

Normally convergence criteria are divided into a relative and an absolute.
Where can I find and set the absolute tolerance for my transient flow simulation.

Thank you for your time
0 Replies Last Post 9 gen 2014, 05:42 GMT-5
COMSOL Moderator

Hello Morten Hygum

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content