Menu

Discussion Forum

New Discussion
Filtra

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

identity pair,assembly and port

Posted 13 gen 2014, 20:37 GMT-5 RF & Microwave Engineering Version 4.3b 0 Replies

Simida Kalijiwa
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

My name is Guanjun Wang, a Chinese undergraduate student, recently, I had encountered a problem about the identity pair. Using the assembly between two unions and creating a identity pair which consists of source boundary and destination boundary ,then i enable the port on the identity pair( you can see it in the attached image ), and set the port as a light source(a plane wave whose E field is polarized in the x direction),yet no matter what kind of methods i used to divided the meshes(including copy one face of the identity pair to the other one), the energy(or light) can't go into the structure above. A more detailed description will be presented in the attached image.
Any suggestion will be highly appreciated.
Guanjun Wang
1/14/2014

Attachments:

0 Replies Last Post 13 gen 2014, 20:37 GMT-5
COMSOL Moderator

Hello Simida Kalijiwa

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content