Menu

Discussion Forum

New Discussion
Filtra

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Cross-Channel Flow in a rectangular geometry

Posted 28 gen 2014, 15:03 GMT-5 0 Replies

Sabine Schneider
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I am simulating the flow in a single screw extruder. I simplified the geometry by unwrapping the material from the screw channel. Therefore the geometry of my simulation is rectangular (Inlet and outlet are in the zy plane, geometry is attached). The upper wall of the rectangle moves in both the x- and y-direction and the other walls have a no-slip boundary condition. The stationary study of the velocity shows that the velocity behaves like in the screenshots attached (Down channel flow and cross channel flow).

Regarding the Cross-Channel Flow: Why is the flow not changing its flow direction although it is moving straight ahead towards the wall (because of the y velocity of the upper moving wall)? How are positive and negative flows distinguished in COMSOL?
0 Replies Last Post 28 gen 2014, 15:03 GMT-5
COMSOL Moderator

Hello Sabine Schneider

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content