Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

How to simulate a thermal pressure sensor

Please login with a confirmed email address before reporting spam

Hi there,

I'm trying to simulate a MEMS PIRANI sensor in comsol and got stuck for a long time. Here is a brief introduction about what I want to do:

If the pressure of a confined tiny chamber which has a heater (in my model is the polysilicon beam heated by Joule heating) inside descends, the heat dissipated by the surrounding air will decrease due to the decrease of air density. Thus, when reach equilibrium the heater should have different temperature as a result of different pressure in the chamber.

In the model I set the bottom of the chamber at constant temperature so it can serve as a heat sink. And I applied volume force to let air in chamber dissipate heat generated by the beam.

Things are not working well so I hope if someone can figure out something wrong in my model. I didn't find any similar tutorials so I was like walking blindly in dark. Really really appreciate any help!

Attached is my 2D model. I also have a 3D one but it's too big.

Thanks,
Troy


0 Replies Last Post 4 feb 2014, 21:21 GMT-5
COMSOL Moderator

Hello Yuxi Zhang

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.