Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Spiral Coil
Posted 26 feb 2014, 09:48 GMT-5 Low-Frequency Electromagnetics Version 4.3 1 Reply
Please login with a confirmed email address before reporting spam
Hi,
I am trying to simulate a spiral flat coil. The input is the current I define while I would like to see the magnetic flux density generated. I made three models in the same way, but the dimensions of the coil are different.
Two of the simulations run perfectly, while the other one gives me INVERTED MESH ELEMENT warning when I use coarse mesh and DIVERGENCE error when I use fine mesh.
Could you please help me to understand why 2 of the simulations run while the other one gives me errors?
Thanks,
Nima.
I am trying to simulate a spiral flat coil. The input is the current I define while I would like to see the magnetic flux density generated. I made three models in the same way, but the dimensions of the coil are different.
Two of the simulations run perfectly, while the other one gives me INVERTED MESH ELEMENT warning when I use coarse mesh and DIVERGENCE error when I use fine mesh.
Could you please help me to understand why 2 of the simulations run while the other one gives me errors?
Thanks,
Nima.
1 Reply Last Post 11 mar 2014, 04:34 GMT-4
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
same problem Nima !
i will contact u as i figure out
good luck
i will contact u as i figure out
good luck