Menu

Discussion Forum

New Discussion
Filtra

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Remove interior boundaries of parametric surfaces

Posted 24 mar 2014, 22:57 GMT-4 Geometry, Mesh Version 4.4 0 Replies

Tianyu Dong
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi all,

For a parametric surface, i.e., a bump, x=rho*cos(theta), y=rho*sin(theta), z=z0/2*(1+cos(pi*rho/r0)), where rho runs from 0 to r0, and theta runs for 0 to 2pi; z0 is the height of the bump and r0 is the radius. When I export the mesh, how can I get the true boundary of the bump, i.e., r=r0 at z=0, and discard the two boundaries z=z0/2*(1+cos(pi*rho/r0)) at theta = 0 and 2pi since theta covers the entire 2pi?

Thanks,
Tony
0 Replies Last Post 24 mar 2014, 22:57 GMT-4
COMSOL Moderator

Hello Tianyu Dong

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content