Menu

Discussion Forum

New Discussion
Filtra

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Boundary conditions on 2D axis-symmteric model in Thermal stressProblem

Posted 30 mar 2014, 21:58 GMT-4 Geometry, Mesh, Modeling Tools & Definitions, Parameters, Variables, & Functions, Studies & Solvers, Structural Mechanics 0 Replies

Nazir Hina
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I am imposing the very high temperature field i.e. T(r,z) on 2D axis-symmetric (cylinder) model in order to calculate stresses/strains. As temperature is high enough to yield the material , so I am expecting plastic strain.

Surprisingly, If I use only symmetry boundary conditions (on center and bottom edge) there is no plastic strains!

If, I try to constrain the bottom edge, it causes a large error and convergence issues.

Any suggestion please. I wondering why symmetry boundary conditions are causing no plastic strains!

Thanks,
Hina
0 Replies Last Post 30 mar 2014, 21:58 GMT-4
COMSOL Moderator

Hello Nazir Hina

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content