Menu

Discussion Forum

New Discussion
Filtra

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Magnetic field with coil to a plate

Posted 1 mag 2014, 15:05 GMT-4 0 Replies

cellcom
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello!

I am very very new with Comsol. I am using version 4.4.

What I want to do is to apply an magnetic field, created by a coil, to a plate with a potential applied and see how lorentz force acts.

I have done the example with the 3d coil. Now I want to apply the magnetic field I created to the plate. I think that a good idea is to have two different gemoetries because it's a little bit tricky to draw them all togheter. Is this possible? How can I take the magnetic field I have created with the coil and apply it to the plate?

Thanks in advance!!
0 Replies Last Post 1 mag 2014, 15:05 GMT-4
COMSOL Moderator

Hello cellcom

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content