Menu

Discussion Forum

New Discussion
Filtra

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Binding Outflow Concentration and Velocity to a Second Inflow

Posted 21 lug 2014, 18:58 GMT-4 Fluid & Heat, Chemical Reaction Engineering, Geometry Version 4.3b 0 Replies

Kyle Brubaker
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I'm curious if there is a way tell COMSOL to use the outflow concentrations and velocities of one channel/pipe for the inflow concentrations of a second channel/pipe.

On the attached model, I want the "Outlet 1" to dictate the inlet velocity of "Inlet 2", and "Outflow 1" to dictate the inlet concentration of "Inflow 2".

I have achieved the same effect in the past by connecting the two channels with a curved section of channel/pipe, but the meshing gets tricky with the aspect ratios and size scales that I want to work on.

Any help would be appreciated.
Thanks!
0 Replies Last Post 21 lug 2014, 18:58 GMT-4
COMSOL Moderator

Hello Kyle Brubaker

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content