Menu

Discussion Forum

New Discussion
Filtra

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Difference between 1 turn Multi-Turn Coil and Single Turn Coil

Posted 2 ago 2014, 04:10 GMT-4 Low-Frequency Electromagnetics Version 4.4 3 Replies

Akim Borbuev
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi all,

will there be any difference if i use Multi-Turn Coil with 1 turn or Single Turn Coil for a power cable conductor (copper)? Ideally there must not be any difference, however, I noticed that they give little different results when i evaluated Resistive Losses (252 W/m for Multi-Turn Coil with 1 turn and 257 W/m for Single Turn Coil). Therefore, Which one should i use?

Regards,
Akim
3 Replies Last Post 5 ago 2014, 01:29 GMT-4
Jens Krause
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 4 ago 2014, 02:22 GMT-4
Hi Akim,

are you working in 2D or 3D?

yes there is a difference. In a single turn coil the current density varies across the cross section whereas the
electric field is constant. For a multiturn coil is is the other way round.

In a DC application the difference in the magnetic field is often zero, but in AC you will see eddy currents in the single-turn coil but not for the multi-turn coil.

I suggest only to use multicoil domains when there are _many_ wires and when skin depth is larger than wire dimensions.

Regards

Jens
Hi Akim, are you working in 2D or 3D? yes there is a difference. In a single turn coil the current density varies across the cross section whereas the electric field is constant. For a multiturn coil is is the other way round. In a DC application the difference in the magnetic field is often zero, but in AC you will see eddy currents in the single-turn coil but not for the multi-turn coil. I suggest only to use multicoil domains when there are _many_ wires and when skin depth is larger than wire dimensions. Regards Jens
Akim Borbuev
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 4 ago 2014, 02:35 GMT-4
Thank you for your response, Jens. I am working in 2D. So for solid conductor I should use Single Turn Coil and for stranded one I have to use Multi Turn Coil?
Thank you for your response, Jens. I am working in 2D. So for solid conductor I should use Single Turn Coil and for stranded one I have to use Multi Turn Coil?
Jens Krause
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 5 ago 2014, 01:29 GMT-4
Yes, but if the skin depth is smaller than the dimensions of a single strand you should also consider building many single turn coils. Which means extra work, but sometimes the difference matters. Good luck, Jens.
Yes, but if the skin depth is smaller than the dimensions of a single strand you should also consider building many single turn coils. Which means extra work, but sometimes the difference matters. Good luck, Jens.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content