Menu

Discussion Forum

New Discussion
Filtra

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Modeling ETD ferrite core

Posted 25 ago 2014, 12:18 GMT-4 Low-Frequency Electromagnetics, Studies & Solvers Version 4.3b 2 Replies

Keijo Jacobs
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I am trying to model an ETD ferrite core (core losses) and i have been following the tutorial for an E core. (www.comsol.se/model/download/157243/models.acdc.ecore_transformer.pdf)

However i experience a problem with the solver. Error message:

Nonlinear solver did not converge.
In segregated group 2:
Time : 0
Internal error in solver.
Last time step is not converged.

The file is attached. Any idea how to fix this?
Thank's very much in advance.

PS: I know i could make an approximation and simulate the core in 2d, but i want to compare with a more complex transformer, that needs 3d simulation

Attachments:

2 Replies Last Post 28 ago 2014, 05:00 GMT-4
Dima Apter
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 10 years ago 26 ago 2014, 01:30 GMT-4
Dear Keijo,

I guess you need to add "Coil Current Calculation" steps (one step for each coil) to your solver sequence, before the "Time Dependent" step. "Coil Current Calculation" is required for Numeric coils. Also the Time Dependent solver parameters should me modified.
Everything is mentioned in the pdf you refer to. See the modified model, seems that it converges.

Best Regards,
Dima.

--
Dima Apter
www.a2z-consulting.com
Dear Keijo, I guess you need to add "Coil Current Calculation" steps (one step for each coil) to your solver sequence, before the "Time Dependent" step. "Coil Current Calculation" is required for Numeric coils. Also the Time Dependent solver parameters should me modified. Everything is mentioned in the pdf you refer to. See the modified model, seems that it converges. Best Regards, Dima. -- Dima Apter www.a2z-consulting.com
Keijo Jacobs
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 10 years ago 28 ago 2014, 05:00 GMT-4
Thx Dima,

for some reason the "Coil Current Calculation" was shown grayed out. Can't reproduce it, though. I worked it through again and it works fine.

best regards

Keijo
Thx Dima, for some reason the "Coil Current Calculation" was shown grayed out. Can't reproduce it, though. I worked it through again and it works fine. best regards Keijo

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content