Menu

Discussion Forum

New Discussion
Filtra

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Changing dimension

Posted 18 ago 2009, 00:45 GMT-4 1 Reply

Rashi Tiwari
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi

I am modeling stress in cylinder. I would like to study the stress generated in the geometry with change in the hight of the cylinder and change in the internal diameter.

How can i do it.

thanks
Rashi
1 Reply Last Post 18 ago 2009, 11:09 GMT-4
R. F. Hamou
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 2 decades ago 18 ago 2009, 11:09 GMT-4
Hi,

You can use the moving mesh application mode ALE, and then the size of your cylinder or whatever will change in function of your physics (let's say the stress).

Take a look to the Comsol documentation.

Good luck

Hi, You can use the moving mesh application mode ALE, and then the size of your cylinder or whatever will change in function of your physics (let's say the stress). Take a look to the Comsol documentation. Good luck

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content