Menu

Discussion Forum

New Discussion
Filtra

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Problems finding the correct application mode for a ultrasonic stimulation

Posted 27 ago 2009, 07:08 GMT-4 Version 4.0a 1 Reply

Sebastian Sturm
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello,

currently I'm working with comsol multiphysics at the university to do some thermography analysis on defective steel parts. The intention is a thermal stimulation of these parts by using different methods of heat insertion. In the past I created some inductive stimulated models.

Now I want to create a ultrasonice stimulated model to find defective areas in a steel part. The following link shows a picture which explains what I tried to describe.

i30.tinypic.com/nf5u78.png

I only want to create a very simple steel block with a gap on the surface. After a ultrasonic stimulation there should be a temperature gradient where the gap is located.

My first problem is, that I don't know which application modes I should use. I had a rough idea using the acoustics module combined with the general heat transfer module, without success.

I hope there is anybody who could help me creating such a model.

Or is there a tutorial model for such area of application?

Thanking you in anticipation
1 Reply Last Post 4 mar 2012, 06:23 GMT-5
COMSOL Moderator

Hello Sebastian Sturm

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Muhammad Mohsin Rehman
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 4 mar 2012, 06:23 GMT-5
Hi Stefan,

I also have a similar problem. I am trying to stimulate a combination of oil and water in comsol and try to see the effect as temperature rise or pressure gradient.

Have you solved your problem.If yes, can you please send me some helping material or your model?

Many thanks in advance for any of your help.
Hi Stefan, I also have a similar problem. I am trying to stimulate a combination of oil and water in comsol and try to see the effect as temperature rise or pressure gradient. Have you solved your problem.If yes, can you please send me some helping material or your model? Many thanks in advance for any of your help.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content