Menu

Discussion Forum

New Discussion
Filtra

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

droplet modelling

Posted 27 feb 2015, 04:42 GMT-5 Fluid & Heat, Computational Fluid Dynamics (CFD), Microfluidics 2 Replies

Krishna Raj G G
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

can anyone tell me the correct procedure for modelling a water drop on wetted surface.... i used 2 phase flow level set and phase field... but its not working.. i jst want to make dat drop on the horizontal wetted wall. plz reply....
2 Replies Last Post 18 apr 2017, 14:48 GMT-4
COMSOL Moderator

Hello Krishna Raj G G

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Vamsi Manda
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 8 years ago 24 lug 2016, 10:31 GMT-4
Hi
Even I am in need of this.Can anyone please reply?
Hi Even I am in need of this.Can anyone please reply?
Mohammad Amin Kazemi
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 8 years ago 18 apr 2017, 14:48 GMT-4
Hi
It depends on what you want to get from your simulation.

1) If the drop is going to move relatively fast or displace significantly from its initial position, I'd go with one of the "level set" or "phase field" methods.

2) If it is resting on a substrate and/or experiencing a relatively small deformation and displacement (i.e evaporation, condensation,...), I'd select the "laminar flow moving mesh" as it treats the interface more accurately.

Amin,
Hi It depends on what you want to get from your simulation. 1) If the drop is going to move relatively fast or displace significantly from its initial position, I'd go with one of the "level set" or "phase field" methods. 2) If it is resting on a substrate and/or experiencing a relatively small deformation and displacement (i.e evaporation, condensation,...), I'd select the "laminar flow moving mesh" as it treats the interface more accurately. Amin,

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content