Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Simulation of indentation of an AFM cantilever on a polymer film

Please login with a confirmed email address before reporting spam

Hi,
I’m trying to modeling the indentation of a AFM cantilever with a spherical tip into a polymer thin film on a Si substrate. The geometry of the cantilever consists of 3 parts: spherical tip, cantilever, and cantilever holder (the biggest rectangular block on right), and all are set to be the same material, e.g. Si (C). The sample block set consists of a thin polymer film on thick Si (C) substrate. The separation between the lowest point of the spherical tip and the polymer surface is set 10nm. What is expected to see is the deflection of the cantilever part ONLY in Z direction when the cantilever set starts to indent into the polymer. However, except the designated Z displacement of the cantilever set, the unexpected X and Y direction movement both showed up, as shown in attached "TC_postprocess" file. The boundary conditions I set are:
1. the marked boundary was set with prescribed displacement on Rz as well as a load on Fz.
2. the all vertical boundaries and the bottom boundary of the sample block were set fixed.
3. all other boundaries were set free.
4. contact pair: lower hemi-sphere of the tip set as master; top boundary of the sample block set as slave.
5. the prescribed displacement of the cantilever holder in Z direction, Rz, was set 20nm in -Z direction from the initial position.
I’m not sure my boundary settings were set correct. Can anyone give me some suggestions on the settings for which the indentation process results in only Z direction deflection of the cantilever? Thanks.


3 Replies Last Post 9 lug 2010, 03:00 GMT-4

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2 lug 2010, 06:20 GMT-4
can you please upload the .mph file of the model that you have showed in .gif format.

Thankyou,
Anurag
can you please upload the .mph file of the model that you have showed in .gif format. Thankyou, Anurag

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 6 lug 2010, 11:07 GMT-4
Hi Anurag,
Thanks for your response. It seems no way to upload ".mph" file on via the "Attach File" of the post reply page. Can you show me how to do it first?

TC
Hi Anurag, Thanks for your response. It seems no way to upload ".mph" file on via the "Attach File" of the post reply page. Can you show me how to do it first? TC

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 9 lug 2010, 03:00 GMT-4
open ziddu.com and upload there.After uploading the file in ziddu.com, paste the download link here.

Thankyou
Anurag
open ziddu.com and upload there.After uploading the file in ziddu.com, paste the download link here. Thankyou Anurag

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.