Menu

Discussion Forum

New Discussion
Filtra

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Symmetry for "Electric Currents (ec)"

Posted 23 apr 2015, 07:44 GMT-4 Low-Frequency Electromagnetics Version 4.4 3 Replies

Edmond Law
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi All,

I have a symmetric model using "Electric Currents (ec)", so I am wondering if there is a symmetry boundary condition in Electric Currents like other physics? (I tried right-clicked on the physics but the option is not there) Thank you.
3 Replies Last Post 24 apr 2015, 00:02 GMT-4
Daniel Connelly
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 9 years ago 23 apr 2015, 12:34 GMT-4
For isotopic media (conductance, permittivity) I think zero charge will do the same thing. Is that available?
For isotopic media (conductance, permittivity) I think zero charge will do the same thing. Is that available?
Nirmal Paudel COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 9 years ago 23 apr 2015, 20:51 GMT-4
Hi,

The default "Electric Insulation" boundary condition acts as symmetry boundary condition in Electric Current physics. Similarly, for Electrostatics, Zero Charge boundary condition acts as symmetry BC.
You would however need to be careful to apply the voltage or current input to the symmetry model as you would have to manually consider the symmetry factor here.

Best Regards,
Nirmal
Hi, The default "Electric Insulation" boundary condition acts as symmetry boundary condition in Electric Current physics. Similarly, for Electrostatics, Zero Charge boundary condition acts as symmetry BC. You would however need to be careful to apply the voltage or current input to the symmetry model as you would have to manually consider the symmetry factor here. Best Regards, Nirmal
Edmond Law
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 9 years ago 24 apr 2015, 00:02 GMT-4
Thank you so much for both of you reply, I can't find zero charge in there as well, soI will try using insulation condition as symmetry plane.
Thank you so much for both of you reply, I can't find zero charge in there as well, soI will try using insulation condition as symmetry plane.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content