Menu

Discussion Forum

New Discussion
Filtra

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Assembly problem singularity before contact is established

Posted 24 apr 2015, 04:24 GMT-4 Studies & Solvers, Structural Mechanics 0 Replies

Marina Nicolas
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi all,

I am trying to use contact in my model. After looking at the COMSOL manual and the discussion forum what I do is first to create an assembly in my geometry and I create the imprints. Then I create the contact pair in the definition section, I mesh the boundaries where there is contact and finally I add contact pair under solid mechanics.
I am getting an error regarding the assembly, before the contact is present : "repeated error test failures. May have reached a singularity "

Any ideas of what I am doing wrong?
0 Replies Last Post 24 apr 2015, 04:24 GMT-4
COMSOL Moderator

Hello Marina Nicolas

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content