Menu

Discussion Forum

New Discussion
Filtra

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Geometry

Posted 27 apr 2015, 00:19 GMT-4 Version 4.4 1 Reply

Kalpana Singh
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello

How to make the faces/edges curved/rounded of a 3D block.
1 Reply Last Post 27 apr 2015, 08:36 GMT-4
Jeff Hiller COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 10 years ago 27 apr 2015, 08:36 GMT-4
For some simple cases, 3D filleting can be performed "manually" using the standard CAD operations provided by the core COMSOL Multiphysics, but in general it is a capability that was introduced at version 5.0 in the Design Module: www.comsol.com/design-module
Best regards,
Jeff
For some simple cases, 3D filleting can be performed "manually" using the standard CAD operations provided by the core COMSOL Multiphysics, but in general it is a capability that was introduced at version 5.0 in the Design Module: http://www.comsol.com/design-module Best regards, Jeff

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content