Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

"Empty Expression"

Please login with a confirmed email address before reporting spam

I am trying to run a Free Tetrahedral mesh on a project I've designed. However, when I attempt to add a distribution to the simulation, it refuses to and gives a pop-up error of "Empty Expression."

Any idea why it is doing that? Thanks.

1 Reply Last Post 7 giu 2015, 12:44 GMT-4
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)

Please login with a confirmed email address before reporting spam

Posted: 9 years ago 7 giu 2015, 12:44 GMT-4
Hi
Normally that means an required entry is all empty (normally you leave a "0" or a "1" or something relevant in ALL model tree field entries).
Or it means you have forgotten to define the Entities on to which your Distribution applies, these are different (or might be) from the ones of the main mesh node

--
Good luck
Ivar
Hi Normally that means an required entry is all empty (normally you leave a "0" or a "1" or something relevant in ALL model tree field entries). Or it means you have forgotten to define the Entities on to which your Distribution applies, these are different (or might be) from the ones of the main mesh node -- Good luck Ivar

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.