Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
measure voltage at boundary
Posted 2 set 2015, 14:00 GMT-4 Structural Mechanics Version 4.4 1 Reply
Please login with a confirmed email address before reporting spam
Hi
i'm trying to simulate the wave propagation in a piezoelectric transducer. The wave is created by an short electric rectangle pulse. for this I used an electric potential boundary condition. I want to measure the voltage induced by the pulse echo, which should be measured at the same boundary as the initial electric pulse.
But after the rectangle pulse the voltage stays 0 at the boundary . I assume i shouldn't use the electric potential boundary condition. But I don't know what else to use.
I hope someone can help me.
Thank you!
i'm trying to simulate the wave propagation in a piezoelectric transducer. The wave is created by an short electric rectangle pulse. for this I used an electric potential boundary condition. I want to measure the voltage induced by the pulse echo, which should be measured at the same boundary as the initial electric pulse.
But after the rectangle pulse the voltage stays 0 at the boundary . I assume i shouldn't use the electric potential boundary condition. But I don't know what else to use.
I hope someone can help me.
Thank you!
1 Reply Last Post 3 set 2015, 17:02 GMT-4
Please login with a confirmed email address before reporting spam
Posted:
9 years ago
I think I just need to know how to create a Voltage source in in the piezoelectric devices module.