Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Electrical Circuit & Spice Netlist in COMSOL 4.0
Posted 31 ago 2010, 05:09 GMT-4 Low-Frequency Electromagnetics, MEMS & Nanotechnology, MEMS & Piezoelectric Devices Version 5.0 1 Reply
Please login with a confirmed email address before reporting spam
Hi
I have a problem with coupling a model (copper wire) with two terminals to electrical circuit (e.g. current source) in COMSOL 4.0.
I've done it before in COMSOL 3.5 by using a spice netlist and defining two circuit terminal for two ends of the wire which it works, but I need to apply different currents with phase difference to a multi wires model, so I use COMSOL 4.0 which the phase is supported for a current source.
Two terminals are added for two surface boundaries in model (with terminal names: A and B). I use Electrical Circuit in model and add a current source (sin) with nodes 1 and 0, but I don't know how to couple the source to two terminals (A and B).
I imported the netlist of the circuit used in COMSOL 3.5 here, but it doesn't work.
Thanks for any help
Hello Sara Feb.
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.
Please login with a confirmed email address before reporting spam