Menu

Discussion Forum

New Discussion
Filtra

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Brinkman boundary stress condition at inlet and outlet of porous pipe

Posted 22 set 2015, 09:58 GMT-4 Fluid & Heat, Computational Fluid Dynamics (CFD), Porous Media Flow, Modeling Tools & Definitions, Parameters, Variables, & Functions Version 5.0 0 Replies

Johannes Weinzierl
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I am trying to simulate flow through porous pipe, for which i have selected Brinkman equation. This porous pipe is nothing but a honycomb which has small tubes with hydraulic diameter of ~1.5 mm & it is connected between two pipes. velocity of air at the inlet of main pipe is 25 m/s and temperature is 500 °C.

The problem I am facing is I want to give boundary condition for this porous pipe for which I believe that boundary stress at inlet and outlet is suitable.

so can you please suggest me some correction in the formula for general stresses for boundary stress condition that I have derived?

I have attached my problem here, in which for boundary stresses I have written the formula for general stresses.

Attachments:

0 Replies Last Post 22 set 2015, 09:58 GMT-4
COMSOL Moderator

Hello Johannes Weinzierl

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content