Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Compressing Walls and Incompressible Water

Payam Haftbaradaran Esfahani

Please login with a confirmed email address before reporting spam

Dear All,

Could you please kindly help me to solve the singularity problem, occurs in the attached model.

This model concerns about a 2D projection of a water container. There are 2 walls, compressing the enclosed water. So, due to the compression pressure, water bulges out of 2 upper and lower open boundaries. I ignored weight force.
So, the 2 left and right compressing walls approach each other by a constant defined speed, causing water to go through 2 open boundaries.

It is a very simple model, but there is singularity, which I couldn't solve it.

I am looking forward for your invaluable advises,

Thanks in advance,

Payam


0 Replies Last Post 1 ott 2015, 10:42 GMT-4
COMSOL Moderator

Hello Payam Haftbaradaran Esfahani

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.