Menu

Discussion Forum

New Discussion
Filtra

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Surface Integration withing a definite area

Posted 19 nov 2015, 07:16 GMT-5 2 Replies

Khalid Ibne Masood
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello,
I am new in Comsol and trying to calculate the total magnetic flux within a certain area. That area is a portion of a larger plane, but I am willing to find the value within that area only. Whenever I am using a cut plane, the whole area is getting selected. How can I choose only that area.

Thank you.
2 Replies Last Post 19 nov 2015, 21:07 GMT-5
Jeff Hiller COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 9 years ago 19 nov 2015, 07:53 GMT-5
See www.comsol.com/community/forums/general/thread/90392
Jeff
See http://www.comsol.com/community/forums/general/thread/90392 Jeff
Khalid Ibne Masood
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 9 years ago 19 nov 2015, 21:07 GMT-5
Thank you very much Sir !!! It solved my problem
Thank you very much Sir !!! It solved my problem

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content