Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Electric field around a single wire
Posted 2 dic 2015, 05:50 GMT-5 Low-Frequency Electromagnetics Version 5.1 1 Reply
Please login with a confirmed email address before reporting spam
Good morning everyone, and apologies if this question is trivial, but I am very new to Comsol and I need a bit of help...
I would like to model the electric field surrounding a single wire. The geometry is clearly not a problem, but I can't figure it out what kind of solver to use, or what kind of boundaries.
I tried the "electric current" with a voltage and a ground assigned to the start and end of the wire but is did not seem to work.
Going on the forum, I saw you could use the MEF properties, but I don't really know how...
Thanks in advance!
I would like to model the electric field surrounding a single wire. The geometry is clearly not a problem, but I can't figure it out what kind of solver to use, or what kind of boundaries.
I tried the "electric current" with a voltage and a ground assigned to the start and end of the wire but is did not seem to work.
Going on the forum, I saw you could use the MEF properties, but I don't really know how...
Thanks in advance!
1 Reply Last Post 2 dic 2015, 21:32 GMT-5
Please login with a confirmed email address before reporting spam
Posted:
9 years ago
Hi,
I used the AC/DC module. Check out my post titled "Help with "Charged particle tracing module"", in which I have also attached my model file. That could help.
Thanks
I used the AC/DC module. Check out my post titled "Help with "Charged particle tracing module"", in which I have also attached my model file. That could help.
Thanks