Menu

Discussion Forum

New Discussion
Filtra

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

MicroFludics Co-axial device simulation failed (after computing the first time)

Posted 14 dic 2015, 00:06 GMT-5 Fluid & Heat, Computational Fluid Dynamics (CFD), Microfluidics Version 5.2 0 Replies

Adeel Ahmad
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Dear all,

I have tried to setup my simulation like shown in my model and it computed in 30 min. but then my system crashed I could not save my results. I am using these conditions again and it has been days on the same pc and the simulation is still not completed, kindly look at my settings let me know where I am going wrong

Attachments:

0 Replies Last Post 14 dic 2015, 00:06 GMT-5
COMSOL Moderator

Hello Adeel Ahmad

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content