Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Escape Radius/Velocities of Particle flowing in a past a T-junction
Posted 1 gen 2016, 13:35 GMT-5 Fluid & Heat, Computational Fluid Dynamics (CFD), Microfluidics, Chemical Reaction Engineering Version 5.2 1 Reply
Please login with a confirmed email address before reporting spam
I am trying to model an automated syringe(100um) sampling out 45um particles as they slowly flow through a channel about 1cm in diameter. I would like to know what is the effective area in which I can apply a negative flow rate or pressure to the syringe, a particle flowing past might be pulled up.
[Attached]: Model Diagram
[Attached]: Model Diagram
Attachments:
1 Reply Last Post 4 gen 2016, 05:11 GMT-5
Please login with a confirmed email address before reporting spam
Posted:
9 years ago
Hi Moaraj,
I don't know how deep you are already in COMSOL, but to get started with what you are trying to achieve I would recommend the following tutorial:
ch.comsol.com/model/flow-past-a-cylinder-97
You may adjust the dimensions and flow rate to your needs. and add a second outlet. I would recommend starting in 2D first and when you have a good understanding about the type of your flow regime, upgrade to a full 3D model.
Best regards,
Sven
I don't know how deep you are already in COMSOL, but to get started with what you are trying to achieve I would recommend the following tutorial:
ch.comsol.com/model/flow-past-a-cylinder-97
You may adjust the dimensions and flow rate to your needs. and add a second outlet. I would recommend starting in 2D first and when you have a good understanding about the type of your flow regime, upgrade to a full 3D model.
Best regards,
Sven