Scopri come la simulazione multifisica viene utilizzata per ricerca e sviluppo
In questa sezione troverete i lavori presentati alle Conferenze mondiali COMSOL. Le presentazioni descrivono ricerche e prodotti innovativi progettati con COMSOL Multiphysics da colleghi di tutto il mondo. I temi delle ricerche presentate abbracciano un'ampia gamma di settori produttivi e aree applicative, in ambito elettrico, meccanico, fluidodinamico e chimico. Lo strumento di Ricerca Rapida vi permetterà di trovare le presentazioni che si riferiscono all'area di vostro interesse.
Visualizza gli articoli presentati alla COMSOL Conference 2020
The aim of this work was to simulate the electro-thermal behavior of a micro-hotplate used as a gas sensor, in order to compare the obtained results with a real structure. The structure has been designed in 3D and a stationary and a temporal study has been realized. Per saperne di più
The mechanical simulation and analysis of the cantilever-to-anchor configuration for an out-of-plane structure used in transducer applications is reported. The polymer-based Buckled Cantilever Plate “BCP” structure, gives the ability to orient an active device from a horizontal to a ... Per saperne di più
The silicon cantilever with the planar coil was applied to the magnetic flux density measurements. The influence of shape and dimensions of planar coil on magnetic energy density was described. In cause of magnetic anisotropy of analyzed silicon structure FEM method and couple field ... Per saperne di più
This paper addresses the study of thermal behavior of thermoset polymer matrix filled with microparticles. A numerical model was developed with COMSOL Multiphysics to get a random spatial distribution of fillers in a representative volume element (RVE). This model was then compared to an ... Per saperne di più
Operation of a modified type microthrottle (MT) pump is analyzed by numerical simulation. Conventional MT pumps have disk type piezoelectric membranes while the analyzed type has a membrane of a rectangular shape. This could be advantageous in case the pump is stacked into an array for ... Per saperne di più
Monitoring of indoor CO2 concentration is of particular interest to detect room occupancy in order to optimize power consumptions of building. One approach to monitor the indoor CO2 concentration is to use optical detection using specific absorption lines of CO2 molecules in the infrared ... Per saperne di più
Several analytical solutions describing the mechanical behavior of a silicon micro membrane deflection, perfectly embedded and subjected to a uniform and constant pressure have been proposed. The obtained results are compared with those obtained by using COMSOL software for a rectangular ... Per saperne di più
The possibility to detect and probe molecules in microfluidic devices gives rise to interesting applications. There are different approaches how to detect and probe particles, but a common step, for most methods, is to place the particles on a sensor. This can be done by applying ... Per saperne di più
In the presented work the dynamic simulation of a silicon anodization process is performed. Two mechanisms of etch form development (diffusion in electrolyte, current flow) are considered and simulated. Influence of electrolyte conductivity and radius of the opening in the masking layer ... Per saperne di più
The purpose of this study is to understand the growth mechanism of copper (Cu) films on a Cu-Zn system substrate with a pre-defined pattern. The pattern was defined by conducting a selective etching process on a two-phase polycrystalline substrate. As a result of this process, there were ... Per saperne di più