Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
geometry meshing
Posted 7 mar 2016, 05:02 GMT-5 Geometry, Mesh 0 Replies
Please login with a confirmed email address before reporting spam
i have problem about my mesh geometry (as attached). i build the 3D geometry using these sequences :
1. build 2 parametric surface by interpolating point value (from xyz file)
2. build block
3. conversion to solid
4. build sphere (later used as injector geometry)
5. difference (sphere as substracted material)
6. form union
due to the sharpness of the geometry edge (in red circle), i have to set my minimum value until there's no problem's notifications (edge is smaller etc). Unfortunately by increasing the resolution of geometry, the number of element also become greater and increase the computational time. how could i deal with this edge sharpness so i could do minimal effort for meshing geometry and saves my computational time?
thankyou and kind regards,
rizal
Attachments:
Hello Rizal Abda
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.