Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Returned solution has not converged.
Posted 8 nov 2010, 22:54 GMT-5 2 Replies
Please login with a confirmed email address before reporting spam
Hello All,
When I try to use 3D-AC/DC Module-Magnetostatics(emqa) to get the inductance of a three turns copper coil with magnetic materials covered, I will always meet the problem:
Failed to find a solution:
Divergence of the linear iterations.
Returned solution has not converged.
I have set the geometry well, so could it be the problem of mesh? Or is it because the geometry is too complicated?
If anyone happens to know how to solve this problem, plz tell me how to fix it.
Thank you very mcuh.
When I try to use 3D-AC/DC Module-Magnetostatics(emqa) to get the inductance of a three turns copper coil with magnetic materials covered, I will always meet the problem:
Failed to find a solution:
Divergence of the linear iterations.
Returned solution has not converged.
I have set the geometry well, so could it be the problem of mesh? Or is it because the geometry is too complicated?
If anyone happens to know how to solve this problem, plz tell me how to fix it.
Thank you very mcuh.
2 Replies Last Post 9 nov 2010, 14:30 GMT-5
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Try to change the tolerance in your solver configuration. Increase it a little bit.
You can also try to use a corser mesh
You can also try to use a corser mesh
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Thanks for your answer.
But coarser mesh will result in the failure of mesh. Is there any better other ways to find the inductance of the coil shape inductors?
But coarser mesh will result in the failure of mesh. Is there any better other ways to find the inductance of the coil shape inductors?